Backward tilt double inlet centrifugal fan

Brief Introduction of MDK Serial Fan

The MDK centrifugal fan is domestic fan,which base on the advanced technology of American, England, Germany, France, Italy,and have imported French product technique and manufacture technological.The test proved,MDK centrifugal fan not only has tight structure, high efficiency, low noise,but also has large capacities and pressure,wide performance curve, especially in the large capacities which efficiency is higher, even the

performance is excellent, whatever in the national or intermational fan field.Model MDK serial Centrifugal Fan whole are designed with double suction type and driven by V-belt. The fan are suited to equipped for ventilation plant on the trade as Chemical fibre,textile plants, market shopping, restaurant elc..is also is a ideal products for air-condition and cleaning plant. It has 13 specifications for normalizaation from 400# to 1800#. The outlet flange position of fan are fixed three kinds (0°，90°,180°).According to the range of speed the fan has divided into higher (A) and lower speed(B).

Outline For Model BM DK Centrifugl Fan

Model BMDKis a kind of anti-expiode centrifugol fan, which are suited to the explosible environment,where the mixture gas is inflammable or free
explosion with the temoperature of flashing point are lower than ambient and concentration is allowable.the nerial of fan are generally used in ventilations system. For the fan, the highest temperature of medium lese than 80C. Contants of dust and hard grit lese than 100mg/m" the largest diameter of grift less than 1mm.

Characters of Model BMDK

1. The fan are taken same with model BMDK serial,  Such as type, construction, figure dimensions, performance, it can be selected directly
from table, The motor has explosive-proof (B type)and ordinary (Y type) please noted on order.
2. Except Satisfied the requirement of intersity and rigidlity with fan to Consider the explosive proof fully is needful, As Scraping happens between rotor and statical unit the flashing must be averted foom.the material of inlet made from steel sheet and impeller always made from aluminium-alloy.  The explosive-proof motor and electric appliance are confirmed with GB3836, The manufacturer must be certificated and Supplying the qualification.
3. Guards for rotating impeller, shaft, pulley,belts, spindles and Couplings shall be of Substantied construction to avoid accidental contact between the guards and rotating components, On this component must have earth-grounding to connect confidently with greater than 2m deep underground.